Here, I am going to teach you how to make a 3d model wash basin in 3ds max
[1]first, go to spline and select the rectangle of this size.
[2]Then go the modifier panel and select extrude modifier of this parameter.
[3]Then convert it into editable poly.
[4]Switch to the polygon mode.
[5]Then insert a polygon of amount-7 as shown below.
[6]Then extrude by 4.
[7]Take a line of shape like this.
[8]Then go to the modifier panel and select LATHE and apply it.
[9]Also apply SHELL modifier.
[10]You have a shape like this.
[11]Take another line of shape like this.
[12]Again apply LATHE modifier on it of this parameters.
[13]Also apply SHELL and you have a shape like this.
[14]Take a cylinder of these parameters.
[15]Again take another cylinder of these parameters.
[16]You have a shape like this.
[17]Then take chamfer cylinder of this size and place it like this.
[18]Then take a tube of this size and apply BEND modifier on it.
[19]And place it like this.
[20]Then again take a chamfer cylinder of this size and place it like this.
[21]Then take a wall.
[22]After that take box of this size and apply BEND modifier.
[23]And place it like this.
[24]Again take a wall.
[25]And place it like this.
[26]Take a plane.
[27]Select the wash basin, Open the material editor and adjust it like this.
[28]Then select the lower part and take this color and adjust it like this.
[29]Select the wall and apply material like this.
[30]This is the final output.
how to build a 3d model
how to make 3d graphics
iges model
0 responses so far ↓
There are no comments yet...Kick things off by filling out the form below.
You must log in to post a comment.